How Does It Works?
 |
The
Pool Cooler provides a low cost, simple
to install, readily
detachable and low maintenance
way to control the temperature of your pool. |
Swimming pools can be
difficult to keep cool as the outside
temperature increases during the day. By the evening, the
temperature of the pool water can increase dramatically.
Outside temps were 94°-99°. Pool size
approximately 30,000 gallons.
Filter system ran daily from 6 a.m. to 12 noon.
Note: Cooling could be further
improved simply
by circulating water during the night hours. |
The misting or multiple-flow aspects of the
The Pool
Cooler
takes advantage of the cooling effect of
evaporation by
introducing quantities of water vapor or mist into the
atmosphere - evaporative cooling. The Pool Cooler diverts
a portion of the total amount of pool water
to be cooled through
a header pipe and then to a vertical member
containing a
multitude of orifices. The flow of the water
through the orifices
creates a misting effect facilitating evaporative
cooling.
After the initial installation of the adapter to the water return
line (less than 2 minutes), The Pool Cooler connects and is
fully functional in less than 30 seconds. Disconnection of the
The
Pool Cooler is just as quick. Protruding about 4 -6 inches
from the pool's edge, The Pool Cooler is virtually nonexistent
to all swimmers.
This device works while your filtration system is running
therefore
the cost to operate is no more than what you are
currently spending to
filter your water. When your pool's
water reaches the desired temperature, simply
remove the
The Pool Cooler, leaving the adapter installed
for the next
time the
cooler is needed. Being made of a durable plastic,
it is most likely the last cooling device you will ever need.
For best results, run your filtration system
at night when the
outside air is at its' coolest. It is also recommended to
install
The Pool Cooler at each end of
your pool.
